![]() ![]() Technically you can use whatever id you want as long as it is a 32 bit “address” and is unique. Use the address from the above loopback address. Create OSPF Instanceįirst we’ll create the instance. interface/bridge/add name=loopback /ip/address/add address=1.2.3.4 interface=loopback Create a Loop-back interfaceįirst it would be a good idea to create an loopback interface that will stay up. Run these commands on each Mikrotik changing out the router-id. The following commands should work with RouterOS version 7+. Setting up OSPF between Mikrotik routers is not too difficult. Posted in Networking | Tagged cisco, networking, reboot, reload | Leave a reply Simple OSPF between Mikrotik Routers Write will make our config persistent across reboots/reloads The reload cancel command will cancel the reload. ![]() If we loose access to the router while making changes, once 10 minutes has expired, the router will reload, returning it to the last know working state. To recap reload 10 will reload a router in 10 minutes Now we can run “write” to save our new config.After verifying that everything is working, run the “reload cancel” command to cancel the reload.The plan is to cancel the reload after making sure our changes work Run the command “reload 10” to reboot the router in 10 minutes. ![]() We can take advantage of this behavior to “test” changes on a Cisco router. By default, making changes, for instance an IP address on an interface, will get wiped on a reboot or reload. For instance reload 13:30įor a Cisco config to remain permanent, we have to “write” i.e. The reload command allows you to specify how many minutes like reload 5 Cisco’s can be rebooted with the reload command. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |